In combination with either the rugged Transmatic Lynx 4EHD or, when working out to 70 metres from the power source the Suitcase II wire feeder, the new Transmig 423S and 523S power sources provide superb dip through spray transfer MIG welding, up to 420A or even 520 A at 60% duty according to model. The microprocessor based electronic control circuitry in these power sources ensures precise and consistent welding results and enables the operator to adjust the whole process from the wire feed unit. With arc voltage being monitored at the torch (not the power source output!) the TM423S and 523S are able to run with cable lengths up to 70m without performance degradation. Digital volt/amp metering is standard on these Transmig's with the useful Last Reading Hold feature. In addition, to cover the full range of wire types and shielding gases utilisable with these new machines, both incorporate 3 inductance level settings.
system. Solid state contactor
• Excellent welding characteristics, DIP through transfer welding modes,
absolute consistency and accuracy
• Continuous voltage control (from the wire feeder), full short circuit protection
• Interphase reactor and 3 levels of inductance provide optimum arc characteristics
• 423S is rated at 400A at 45% duty (350A 60%), 523S provides 500A at 60% and up
to 400A continuously
• Available as "W" versions with in-built torch water cooling units
• CE approved, meet EN60974-1 and EN50199 covering the LV and EMC safety and
directives